Evinger Enterprises

Overview-This system comes with a new, electric start, 165GPM (gallon per minute) pump that has been paired with the correctly sized EG series gasifier. The pump also retains the ability to operate on gasoline.

Features

• This system is very easy to setup and operate. Setup time is about 1 hour, which includes unpacking. Unit comes with a setup and operation manual.
• Easy Startup. Startup in 10 minutes.
  
• Two types of filtration give high flow and high quality gas. An organic filter, and oiled foam filter are used to capture particles. The foam filters can be cleaned and reused. The filters can also be used as fuel when they are too fowled or wear out.
  
• Engine wear is similar to propane or natural gas powered engines.*
  
• Any organic based fuel can be used, including: wood chips, wood pellets, food scrapes, plastics, animal waste, crop waste, etc. Fuel must be smaller than 2"x2"x2" cube and less than 20% moisture content. (Never put metal, glass or ceramic into the gasifier).
• Fuel consumption is estimated at 18-25lbs per hour.
• Battery not included.
  
• Electricity is required for approximately 10 minutes to start the gasifier. After this, no electricity is required.

Options

• Need a chipper? Add on one that can handle up to 2" or 3" branches. See above options.
• Increase your fuel flexibility with a Tri-fuel conversion kit. Now you can operate your pump on gasoline, propane, natural gas or wood. Check our kits for more info, here.

Shipping

*- Assuming the gasifier is operated correctly. Evinger Enterprises is not responsible for engine wear.

Pump Type		Trash
Connection		Cam and Groove
HP		5.5
Engine Brand		Honda OHV
Engine/Motor Type		Gas
Tank Capacity (Qt.)		3.81
NPT Port (In.)		2
Length (In.)		22-1/2
Width (In.)		17-1/8
Height (In.)		15-1/2
Material of Construction		Aluminum
Impeller		Cast-Iron
Impeller Type		Semi-Open
Seal Material		Buna N, SiC
Solids Handling Capacity (In.)		13/16
Max. Pressure (PSI)		38
Engine RPM		3600
GPM of Water @ 10 Ft. of Head		165
GPM of Water @ 20 Ft. of Head		157
GPM of Water @ 30 Ft. of Head		148
GPM of Water @ 40 Ft. of Head		133
GPM of Water @ 50 Ft. of Head		115
GPM of Water @ 60 Ft. of Head		90
GPM of Water @ 70 Ft. of Head		61
GPM of Water @ 80 Ft. of Head		30
Max. Head (Ft.)		88
Max. Suction Lift (Ft.)		25
Casing Adapter		Aluminum
Volute/Wear Plate		Cast-Iron
Mechanical Seal		Silicon Carbide/Buna
Check Valve		Buna
Roll Bar Frame		Steel
Number of Impellers		1
Temp. Range (F)		35 to 105
Ignition Type		Electronic
Sensor Type		Low Oil
Includes		1DPN5- 2"Female Coupler, 1DPP2- 2"Male Cam Adapter, 2P567- 2" x 20 Ft Green Suction Hose, 1FYR3- 2" x 50 Ft Blue Discharge Hose, 1P690- 2" Strainer
Agency Compliance		EPA and CARB Certified Engine