Evinger Enterprises

Overview-This system comes with a new, electric start, 10kW generator that has been paired with the correctly sized EG series gasifier. The generator also retains the ability to operate on gasoline.

Features

• The 10kW Gasifier Power System is very easy to setup and operate. Setup time is about 1 hour, which includes unpacking. Unit comes with a setup and operation manual.
• Easy Startup. Startup in 10 minutes.
  
• Two types of filtration give high flow and high quality gas. An organic filter, and oiled foam filter are used to capture particles. The foam filters can be cleaned and reused. The filters can also be used as fuel when they are too fowled or wear out.
  
• Engine wear is similar to propane or natural gas powered engines.*
  
• Any organic based fuel can be used, including: wood chips, wood pellets, food scrapes, plastics, animal waste, crop waste, etc. Fuel must be smaller than 2"x2"x2" cube and less than 20% moisture content. (Never put metal, glass or ceramic into the gasifier).
• Fuel consumption is estimated at 40-60lbs per hour.
  
• Limited Warranty: The rotor, stator and other electrical components are covered by a 2 year limited warranty against defects in material and workmanship from date of purchase. The 1 year limited warranty on the engine is covered separately by the engine manufacturer.

Options

• Need a chipper? Add on one that can handle up to 2" or 3" branches. See above options.
• Increase your fuel flexibility with a Tri-fuel conversion kit. Now you can operate your generator on gasoline, propane, natural gas or wood. Check our kits for more info, here.

Shipping

Caution- Connection of a generator to a home or building requires a transfer switch. Consult a qualified electrician.

*- Assuming the gasifier is operated correctly. Evinger Enterprises is not responsible for engine wear.

Engine
Engine: Briggs & Stratton	Cooling: air	RPM: 3600
Eng Model: Vanguard 303400	Cylinder(s): 1	Horse Power: 16
Governor: mechanical	Displace:  480 cc	Idle Control: no
Choke: manual	Year Manufactured: 2010	Starting: electric
Alternator
Standby: 10kW	Prime: 9.5kW	Primary Voltage: 120/240 VAC
Alternator: Mecc-Alte	Alt Model: 2 - Pole	Alt Type: brushless
Phase: single phase	Freq: 60	Volt Regulator: AVR
Volt Accuracy: 6%	Freq Accuracy: 6%	Volt/Freq Selector: no

Dimensions (LxWxH)- 30"x24"x25"

Mount: roll cage

Noise:  76.5 dBA at 7 meters

Receptacles

Quantity - 4

5-20R, 20A, 125V

Quantity - 1

L5-30R, 30A, 120V

Quantity - 1

L14-30R, 30A, 240V

Quantity - 1

L14-50R, 50A, 240V